How To Remove Kohler Kitchen Faucet Cartridge

On most two handled faucets this can be done by unscrewing the bonnet under the.

How to remove kohler kitchen faucet cartridge.

Turn off the water to your faucet and remove the handle fig. I only managed to scratch the. Unscrew the nut all the way and remove it from the faucet body. Fully open the faucet to both the hot and cold positions to allow any residual water to escape.

Use an adjustable wrench to remove the kitchen faucet nut holding the cartridge down. Loosen the cartridge retaining nut using a pipe wrench or tongue and groove pliers. After you remove the handle you now need to unscrew the bonnet counter clock wise this is what holds the cartridge into place once you remove the bonnet you can then take out the old cartridge and then drop in the new one then tighten up the bonnet back into place by turning it clock wise and then put the handle back on. I did some google searches for multiple variations of kohler faucet handle remove in an effort to see if there were any tricks to removing these handles and most of them implied that they just twisted off without a screw.

Use an allen wrench to remove that nut and the handle. Note the brass screw at the top of the cartridge if there is one. Remove the faucet cap by prying a flat head screwdriver underneath and popping it off. Turn off the water supply for the kohler faucet in which you want to change the cartridge.

Slip a flat head screwdriver under this oval tab to pop it off and reveal the hex nut. Remove the kohler faucet. To remove it use a glove with grips or a jar remover to turn the piece counterclockwise. Some faucets have an adapter over.

Once it has been removed set the bonnet aside so you can proceed with repairs to the o ring or cartridge. Once you have removed the screw you will have access to the bonnet on your kohler faucet. Replace the valve in a two handle faucet. With the handle removed the top of the valve will be visible fig.

This will enable you to screw it off the top of the faucet. Its purpose is to reinforce the cartridge shaft when the faucet body s setscrew is tightened against it. Cartridges turning off the water at the shut off valves under the sink.